ACTFLEX 5000
Non-Asphalt Polymer Resin | Peel-and-Stick | No Open Flame
Self-adhesive sheet membrane with cross-laminated HDPE reinforcement for basements, retaining walls and planter boxes.
Because ACTFLEX 5000 uses a polymer resin rather than bitumen, it develops full-contact adhesion and a mechanical lock with concrete, without bitumen odour or staining. The cross-laminated carrier gives dimensional stability and puncture resistance in both directions (typically 200 N or more), and a factory self-adhesive selvedge makes clean, watertight 75 mm laps without site adhesives. It is chemical and weather resistant and suits basement walls, retaining walls, external lift shaft walls and covered rooftop areas. Designed and manufactured to comply with AS/NZS 4858 and AS 4654.1, with verification testing scheduled. Must be covered by the specified protection, backfill, topping or finish and never left permanently exposed to UV.
specs
Technical Specifications.
Waterproof Time:
Coverage:
Measured area plus upturns, plus 20% for laps and wastage (75 mm side and end laps)
Usable period after opening:
Touch dry time minimum:
Vapour Pressure @ 25°C:
Application Temperature:
+5°C to +35°C
Shelf Life:
24 months, unopened, stored dry and shaded
Membrane
Classification:
Colour:
Tack Free Time:
Recoat Time:
Elongation at Break:
≥ 150%
Recommended
Thickness:
Chemical
Resistant:
Excellent chemical resistance for below-ground and aggressive ground conditions (typical)
Full Cure:
Chemical Base:
Non-asphalt self-adhesive polymer resin with cross-laminated high-density polyethylene carrier film.
Cure Mechanism:
Tear Propagation
Resistance:
≥ 300 N (nail shank tear strength)
Service
Temperature:
Solids Content:
Bond Strength:
Density:
Compressive
Strength:
Flow:
Acceptance of Cyclic Movement:
Dimensional Stability:
Control Elongation at Break:
Control Tensile Strength:
≥ 600 N/50 mm (typical)
Water Immersion Elongation at Break:
Water Immersion Tensile Strength:
Detergent Immersion Elongation at Break:
Detergent Immersion Tensile Strength:
Heat Aging Elongation at Break:
Heat Aging Tensile Strength:
Field Seam Strength:
Temperature Resistance:
Water Vapour Transmission
Water Vapour Transmission:
Application Method:
VOC Content:
Mixing Ratio:
Viscosity:
Storage Temperature:
Flash Point:
UV Resistance:
Hydrostatic Pressure Resistance:
Water Vapour Transmission Rate (WVTR):
Abrasion Resistance:
Bacterial/Algae Resistance:
Application Time:
Environmental Impact:
Packaging Sizes:
Hardness:
Adhesion to Substrate:
Appearance After Curing:
Clean-up Requirements:
Certification Standards:
calculator
Coverage Calculator.
Based on a manufacturers average recommended coverage of Measured area plus upturns, plus 20% for laps and wastage (75 mm side and end laps)
Required:
NaN
pdfs
Product Documentation.
Safety Data Sheet 2 (PDF Download)
Compliance Testing Report 3 (PDF Download)
Low VOC Certificate (PDF Download)
Technical Drawings (PDF Download)
3d
Application Model
Available in (sizes)
Roll dimensions: To current pack schedule.
Need to Know More?
Got a question about ACTFLEX 5000? Our technical team can help with specification, surface prep, coverage and compatibility.
Call (02) 8021 3517
Email info@forspec.com.au