ACTFLEX ULTRA SHIELD
Two-Component Polyaspartic Floor Coating for Direct Application to Concrete
Two-component polyaspartic floor coating for concrete floors and decorative finishes.
ACTFLEX ULTRA SHIELD is a two-component elastomeric polyaspartic floor coating with 90% solids for direct application to well-prepared concrete. The TDS states that it provides a seamless, decorative and protective floor coating and can be applied as a solid-colour finish or as a decorative flake system. It is listed for garage floors, commercial, industrial and residential flooring, food-processing floors, high-wear and traffic-prone environments, permanent-immersion situations, and areas requiring enhanced surface friction when the specified anti-slip broadcast is used. It bridges hairline cracks and absorbs minor substrate movement, but it is not a structural repair or levelling product.
specs
Technical Specifications.
Waterproof Time:
Permanent water immersion after full cure: 48 hours at 25°C and 50% RH.
Coverage:
6–8 m²/L per coat. 4 L pack: approximately 24–32 m² per coat. 20 L pack: approximately 120–160 m² per coat. 40 L pack: approximately 240–320 m² per coat.
Usable period after opening:
Pot life: 30 minutes at 25°C and 50% RH.
Touch dry time minimum:
Hard through: 3.5 hours at 25°C and 50% RH. Light foot traffic: after hard through.
Vapor Pressure @ 25oC:
ASTM E96 moisture vapour transmission: pass.
Application Temperature:
+10°C to +30°C.
Shelf Life:
12 months from date of manufacture, unopened, stored as specified.
Membrane
Classification:
Colour:
Clear or custom colours.
Tack Free Time:
Recoat Time:
1–4 hours at 25°C and 50% RH.
Elongation at Break:
< 100% at break.
Recommended
Thickness:
Chemical
Resistant:
Physical or chemical damage: none recorded.
Full Cure:
48 hours at 25°C and 50% RH.
Chemical Base:
Two-component elastomeric polyaspartic floor coating.
Cure Mechanism:
Two-component polyaspartic cure.
Tear Propagation
Resistance:
High puncture resistance
Service
Temperature:
Solid Contents:
90%
Bond Strength:
Density:
Compressive
Strength:
Flow:
Acceptance of Cyclic Movement:
Dimensional Stability:
Control Elongation at Break:
Control Tensile Strength:
Water Immersion Elongation at Break:
Water Immersion Tensile Strength:
Detergent Immersion Elongation at Break:
Detergent Immersion Tensile Strength:
Heat Aging Elongation at Break:
Heat Aging Tensile Strength:
Field Seam Strength:
Temperature Resistance:
Water Vapour Transmission
Water Vapour Transmission:
Application Method:
VOC Content:
Mixing Ratio:
Viscosity:
Storage Temperature:
Flash Point:
UV Resistance:
Hydrostatic Pressure Resistance:
Water Vapour Transmission Rate (WVTR):
Abrasion Resistance:
Bacterial/Algae Resistance:
Application Time:
Environmental Impact:
Packaging Sizes:
Hardness:
Adhesion to Substrate:
Appearance After Curing:
Clean-up Requirements:
Certification Standards:
calculator
Coverage Calculator.
Based on a manufacturers average recommended coverage of 6–8 m²/L per coat. 4 L pack: approximately 24–32 m² per coat. 20 L pack: approximately 120–160 m² per coat. 40 L pack: approximately 240–320 m² per coat.
Required:
100 Lr
3d
Application Model
